Carbon fiber tube processing and forming technology article
Carbon fiber tube is a particularly common carbon fiber products, in the composite material pipe, the carbon tube belongs to a very high performance of a composite tube, the raw material of carbon fiber tube is still based on carbon fiber composite materials, the entire density is extremely low, the strength is extremely high, but also has
Very good impact resistance and corrosion resistance performance advantages, then how is the carbon fiber tube processed? Editor is in this article to tell you.
There are many ways of forming carbon fiber tube, common carbon fiber tube forming process has molding, winding, drawing, autoclave, coil and other forming process, which kind of forming process can produce carbon fiber tube, the carbon fiber tube forming process is mainly with the manufacturer's mass production equipment and the actual situation of the product is absolute. In the actual production and processing of carbon fiber camp, more will still use molding and winding molding, winding molding can also be, but for the equipment requirements are higher, in order to save temporary carbon fiber and resin immersion, most will choose the carbon fiber prepreg that has been impregnated, so that it is more convenient to use, and the overall work efficiency will be higher.
The overall idea is to put the carbon fiber tube through the prepreg layer through the mold, send it to the curing equipment, and then give a certain curing pressure, so that the carbon fiber tube curing molding.
We look at the entire production process of molded carbon fiber pipe, molded carbon fiber pipe production, mostly square pipe, short pipe more, that is first according to the size of the carbon fiber pipe mold production, square pipe, rectangular pipe is normally composed of upper and lower mold and internal Bi mold three parts, usually, The overall size of the mold is larger than the size of the carbon fiber tube products, and then cut the material according to the inch, and then the trap layer is good. The carbon fiber coating layer by layer is added to the layer according to a certain paving layer, so that the structure of the carbon fiber tube is stable again. After the completion of the carbon fiber tube, the rain ocean is heated, and the press is heated to make the broken fiber tube formed. The surface of the produced carbon fiber coating product is smooth, and the mechanical properties are further increased
In order to further gain the advantages of work efficiency, the round pipe will be rolled, which is similar to the molding process. In the production of carbon fiber pipes, this kind of molding and rolling molding will be affected by the size of the mold. The total length of the carbon fiber pipe produced here by VIA New Materials can be up to 4 meters long and the diameter can be 450mm. To meet the black requirements of customers, there are many applications of carbon fiber tubes, such as a lot of bearing parts, such as landing gear, mechanical hairpins of mechanical equipment, rolling shaft products, etc., are important applications of carbon fiber tubes.
